AL-KO solo 163-55 Traducción Del Manual De Instrucciones Original página 40

en
Daily inspections and maintenance tasks
Carry out the following maintenance tasks regularly, so that your machine has a long working life, and
to avoid damage to the machine.
Before use:
Check the machine for loose bolts and missing parts. Ensure in particular that the bolts of the cutting
knives are tightened correctly.
Confirm that the cooling air passages and cylinder fins are not blocked. Clean these when required.
Clean the fuel tank, and check for leaks and for foreign bodies in the tank.
After use:
Clean the hedge trimmer externally, and check it for damage.
Clean the air filter. If you are working under very dusty conditions, clean the filter several times each
day.
Check the cutting knives for damage, and ensure that they are correctly mounted.
Maintenance schedule
After every refuelling
Before every use
Every 50 hours
Every year
Every two years
Before long-term sto-
rage
40
– Throttle lever
– ON/OFF switch
– Motor
– Bolts and nuts
– Air filter
– Cooling air duct
– Cutting equipment
– Idling speed
– Fuel tank
– Transmission housing
– Spark plug
– Fuel pipe
– Tank cap
– Fuel tank
– Carburettor
– Suction head
Confirm correct functioning
Confirm correct functioning
Visual inspection for damage and firm fit
Confirm general state and tight fit
Clean
Clean
Check for damage and sharpness
Inspect (cutting equipment must not move)
Inspect and clean
Lubrication
Inspect, and replace if necessary
Replace
Replace
Empty and clean
Run the motor until the fuel has been fully
consumed.
Replace
Maintenance and care
163-55 / 163-70