Agri-Fab 45-05122-131 Manual Del Usuario página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 4:
(SEE FIGURE 4)
Turn the spreader upside down as shown in figure 4.
Remove the lock nut and washer from the bolt in the
crossover tube. Leave the bolt in place. See figure 4.
Assemble the hitch tube onto the bolt and secure
it with the same lock nut you removed. DO NOT
TIGHTEN YET. See figure 4.
HITCH
TUBE
STEP 5:
(SEE FIGURE 5)
Attach the ends of the two OUTER hitch braces to the
hitch tube using a 1/4" x 1-3/4" (D) hex bolt and a 1/4"
nylock hex nut (F). DO NOT TIGHTEN. Do not attach
the inner hitch braces at this time. See figure 5.
1/4 NYLOCK
NUT
BOLT
1/4 x 1-3/4
HEX BOLT
STEP 6:
(SEE FIGURE 6)
Assemble a large washer (J), a spacer (I), a large
washer (J), and a wheel (P) onto the end of the axle.
See figure 6.
4
WASHER
STEP 7:
(SEE FIGURE 7)
Attach the wheel to the axle using a 1/4" x 2" hex bolt
(A) and a nylock nut (F). See figure 7.
1/4 x 2
HEX BOLT
5
1/4
NYLOCK
NUT
6
WHEEL
SPACER
6
7

Publicidad

Tabla de contenido
loading

Tabla de contenido