Agri-Fab 45-05122-131 Manual Del Usuario página 7

STEP 8:
(SEE FIGURE 8)
• Assemble a large washer (J), a spacer (I), a large
washer (J), a wheel (P), and another large washer (J)
onto the end of the axle. See figure 8.
WASHER
STEP 9:
(SEE FIGURE 9)
• Install a 1/8" x 1-1/2" cotter pin (B) into the hole in the
end of the axle and secure it by bending the ends
around the axle. See figure 9.
SPACER
WASHER
WHEEL
WASHER
1/8 x 1-1/2
COTTER PIN
STEP 10:
(SEE FIGURE 10)
• Turn the spreader upright on its wheels.
• Insert the pinched end of the flow control rod through
the hole in the in the flow control arm. See figure 10.
8
STEP 11:
(SEE FIGURE 11)
• Insert the hook end of the flow control rod through
the hole in the slide gate bracket located under the
hopper. See figure 11.
9
7
10
FLOW
CONTROL
ROD
11