DeWalt DW756 Manual De Instrucciones página 7

Ocultar thumbs Ver también para DW756:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fig. F
10
14
4
10
9
8
Installing Spark Guards (Fig. G)
The spark guards
are identified L for left and R for right.
 1 
Refer to Figure G to install the spark guard to the wheel
guard
 28 
using the two bolts
Adjust the edge of the spark guard to within 1/16" (1.6 mm)
of the grinding wheel or other accessory. Tighten the two
bolts
 securely.
 15 
Proceed to install the other spark guard using the
same description.
Fig. G
15
10
Installing Eye Shields (Fig. H)

WARNING: Eye shields are not designed to replace
safety glasses.
Install the eye shields
 2 
(they will fit either side) to the
brackets, as shown in Figure H. Screw the plastic knob
through the washer
, the spark guard
 17 
the eye shield
and finally into the nut
 2 
shields so they are between the wheels and your eyes.
Proceed to install the other eye shield using the
same description.
Tighten the shields in place by tightening the plastic knob
 16 
in the bracket assembly. Remove protective film.
28
13
7
11
11
12
DW756 OnlY
 15 
and flat washers
 10 
.
1
28
 16 
, the spacer
 1 
 18 
. Adjust eye
 19 
Fig. H
16
17
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

CAUTION: Prolonged grinding will cause most
materials to become hot. Handle them with pliers or
thick gloves.

CAUTION: Never attempt to use your bench grinder
unless it is firmly bolted to a workbench or rigid frame
that is also firmly attached to the floor.
Before turning the grinder on, put on safety glasses.
Turn on the grinder and allow it to reach full speed
(3450 RPM - DW756, 3600 RPM - DW758).
Hold the workpiece firmly and against the tool rest.
Hold very small pieces with pliers or other
suitable clamps.
Feed the work smoothly and evenly into the
grinding wheel.
Move the work slowly and avoid jamming the work
against the wheel. As the wheel tends to slow down you
should occasionally release the pressure to let the wheel
return to full speed.
Grind only on the face of the grinding wheel and
never on the side. (Some wheels are designed for side
grinding and will say so on their instruction sheets).
Switch (Fig. A)
The switch
 5 
is located on the front of the grinder, on
the base.
To turn the tool on depress the side of the rocker switch on
,
the left side, marked "ON".
To turn off the grinder, depress the right side of the rocker
switch, marked "OFF".
English
1
18
2
19
5

Publicidad

Tabla de contenido
loading

Tabla de contenido