Installation Steps Front Flares - LUND Elite Serie Instrucciones De Instalación

Installation Steps
Front Flares Disengage side marker bulb assembly from
side marker lamp housing. Remove mounting
nut and remove side marker lamp housing from factory fender flare.
Retain mounting nut.
1
Remove front fender flare, and clean fender mounting area.
3
Use a razor blade to cut and install rubber seal on the
new fender flare edge, that will mount against fender.
5
Align new fender flare with holes in fender. NOTE: The new
fender flare utilizes (6) holes only.
7
NOTE: Actual application may vary slightly from illustrations.
Remove (8) mounting bolts from factory
2
Loosen (3) bolts on factory installed side step, and remove side
step. Remove remaining bolts from fender, and clean fender.
4
Place a bolt through a hole in the new fender flare, and
place a black spacer on the bolt on the opposite side of
the fender flare to retain it in place. Repeat for remaining
bolt
through
this side
6
Reach behind the flare and place a washer and nut
on each bolt to secure fender flare to fender. DO NOT
8
Page 2 of 5
fender flare.
holes.
FULLY TIGHTEN AT THIS TIME.
spacer on
this side