Installation Steps - LUND Elite Serie Instrucciones De Instalación

Installation Steps

With fender flare in final position, tighten all bolts and nuts using
hand tools only. DO NOT OVER TIGHTEN.
9
Reinstall side marker lamp and bulb assembly.
10
With the Side Step in final position, tighten all (3) bolts using hand
DO NOT OVER TIGHTEN.
12
Remove rear fender flare, and clean fender mounting area.
14
NOTE: Actual application may vary slightly from illustrations.
tools only.
fender flare
bolt
Slide (3) bolts through the new Side Step and thread into
11
Rear Flares
13
Disengage (2) rubber mounting pins from rear splash
shield in order to gain access behind fender.
15
Page 3 of 5
spacer
fender
Cross Section
mounting holes in fender.
Remove (8) mounting bolts from rear factory
fender flare.
washer
nut