Troubleshooting - geberit SIGMA10 Manual Del Usuario

If necessary, screw in the screws on
both sides of the actuator plate.

Troubleshooting

Malfunction
Incorrect flushes (too soon,
too late, unwanted)
Water is running continuously
into the WC ceramic
appliance.
The WC ceramic appliance is
not being flushed out
properly.
Flush cannot be released.
Flush cannot be released.
The LED in the sensor
window flashes when a user
is in the user detection range.
Flush cannot be released.
The LED in the sensor
window lights up when a user
is in the user detection range.
4443609099-1 © 08-2018
966.230.00.0 (02)
5
Cause
Sensor window dirty or wet
Sensor window scratched
Software fault
Technical fault
Flush volumes set incorrectly ▶ Contact a skilled person.
Network failure
Battery capacity low
Batteries flat
To test that automatic flush actuation
has been deactivated, place your
hand at a distance of 2–3 cm from
the actuator plate.
Rectification
▶ Clean or dry the actuator
plate.
▶ Contact a skilled person.
▶ Interrupt the power supply
(mains fuse) for
10 seconds.
▶ Contact a skilled person.
▶ Check the power supply
(mains fuse).
▶ Replace the batteries.
▶ Replace the batteries.
EN
15