Functional Description; Trigger Switch - Porter Cable PCC671 Manual De Instrucciones

INSTALLATION AND REMOvAL
OF ThE BATTERY PACk
TO INSTALL BATTERY PACk: Insert
battery pack into the tool until an audible
click is heard (Figure A). Make sure
battery pack is fully seated and fully
latched into position.
TO REMOvE BATTERY PACk: Depress
the battery release button as shown in figure
B and pull battery pack out of the tool.
A
B

FUNCTIONAL DESCRIPTION

Figure C
1.On/Off Trigger
2. Lock-off button
3. Shoe
4. Blade clamp release lever
5. Blade
6. Battery (not included)
7. Battery release button (on battery)
8. Main Handle
9. Secondary Gripping Handle
C
5
4
3
These products use the batteries and chargers listed in the chart below.
Description
20v Max* Lithium-Ion Batteries:
20v Max* Lithium-Ion Battery Charger:
1
9
7
6
Catalog #
PCC680L
PCC681L
PCC682L
PCC685L
PCC690L
PCC691L
PCC692L
PCC695L
OperAting instruCtiOns
WARNING:
protection that conforms to ANSI
Z87.1(CAN/CSA Z94.3) while operating
this power tool.
:
NOTE Before cutting any type of
material, be sure it is firmly anchored or
clamped to prevent slipping.
• Place blade and shoe firmly against work
to be cut.
• Switch on saw motor and allow it to obtain
maximum speed before starting the cut.
• Always hold saw firmly with both hands
while cutting as shown in figure D.
Whenever possible, the saw shoe must
be held firmly against the material being
cut. This will prevent the saw from
jumping or vibrating and will minimize
blade breakage.
D

TRIGGER SWITCh

The tool is equipped with a switch lock-off
feature to prevent unintentional operation.
• To switch the tool on, press the lock off
button (2),then squeeze the on/off switch (1).
• Releasing the trigger turns the motor OFF.
NOTE: This tool has no provision to lock
the switch in the ON position, and should
never be locked in the ON position by any
other means.
BLADE CLAMP RELEASE LEvER
WARNING:
2 and remove battery from tool before
making any adjustments or removing or
installing attachments or accessories.
WARNING:
breakage may occur if the blade does not
8
extend past the shoe and the workpiece
during the cut. Increased risk of personal
injury, as well as damage to the shoe and
workpiece may result.
TO INSTALL BLADE INTO SAW:
1. Open blade clamp release lever to its
full open position as shown in figure E.
2. Insert blade shank from the front.
3. Close blade clamp release lever. Check
to make sure blade is clamped securely.
NOTE: BLADE CAN BE INSTALLED
UPSIDE-DOWN TO ASSIST IN FLUSh-
TO CUTTING.
7
Always use proper eye
Cut hazard. Turn off
Cut hazard. Blade