Maintenance And Service - Garland XTRIM 700 PE Manual De Instrucciones

English
Check the working area and remove any objects that
could cause the cutting tool of the machine to get
tangled on. Also remove any parts that the cutting
tool could violently hit causing these to move in the
direction of the user or other people and/or animals.
Do not allow any other person into the work area.
All other people must be at least at a distance of 15
metres as it is a dangerous area.
It is imperative that the engine is turned off when
carrying the machine from one working area to another.
Never leave this machine unattended.
Do not use accessories except those recommended
by our company as otherwise the use of other non
original accessories could cause severe damages to
the end user, to passers-by and to the machine.
Always follow the safety rules stated in this manual.
7.1. FIXING THE MACHINE AND GUIDANCE
Hold the machine with the harness, hands
on the handles and with the right hand
in such a position that you can action the
controls (accelerator and security switch).
Attention! So as to reduce the risk
of loss of control and possible damages
(that could even be fatal) to the end user and/or
those surrounding him, never use this machine single
handedly.
7.2. CUT WITH THE NYLON HEAD
WARNING: Wear eye and audible protection at all
times. Do not look directly to the cutting line because
can cause serious damage to the head and the eyes.
Use the head line in difficult areas.
If the header hits a rock or other object stop the
machine and check its status. Do not use damaged or
poorly balanced heads.
Hold the trimmer in the way that the head do not
touch the ground. Be careful to not hit the head with
rocks or the ground. The beatings against objects or
the ground will reduce the life of the head, may spoil
creating a dangerous environment for you and the
people close to you.
The nylon threads are shortened with the use, when
they are too short accelerate the engine and press the
head against the ground. Then leave wire from the
head. If you leave too much wire the blade will cut in
excess.
Remember that the end of the nylon threat is the one
that makes the cut. Get a better result if you do not
introduce the entire head in the cutting area. Enter
the head slowly and let the nylon tips cut the grass at
their own pace.
WARNING DANGER: Do not operate the trimmer
cutter in areas with metallic materials.
Always use the proper protective equipment. Don't use
this machine in areas where you can't see properly.

8. MAINTENANCE AND SERVICE

Make periodic inspections of the machine to ensure
that the machine is correct. For a thorough inspection
take the machine to your dealer.
It is necessary to stop the engine and to check
that the cutting tool is stopped before cleaning or
transporting the machine.
34/120