Application Of The Burner To Boiler - baltur BGN 200 LX Instrucciones

COMBUSTION HEAD
ASSEMBLY
Following the drawing, connect the
tube on the attachment on the flan-
ge and fix with the screw
To put in place insulation flange 2,
which must be positioned between
the burner and the plate of boiler
1, the end of the combustion head
must first be removed.
a) Adjust position of connector flan-
ge 4 by loosening screws 6 so
that the combustion head pene-
trates into the combustion cham-
ber the amount recommended by
the generator's manufacturer.
b) Position seal insulation 3 on the
tube unit.
c) Fasten the combustion head as-
sembly to the boiler 1 using the
stud bolts, washers and the nuts
provided 5.
d) With suitable material, comple-
tely seal the space between
the tube unit of the burner and
the hole on the refractory plate
inside the boiler door.

APPLICATION OF THE BURNER TO BOILER

1 Boiler plate
2 Flange with insulating materials
3 Seam with insulating materials
4 Burner securing flange
43 / 119
0006081062_200709
5 Stud bolts, washers and nuts for
fastening to the boiler
6 Nuts screws and washers to fasten
flange to the sleeve