Canifugue Mix Receiver Collar; Adjusting The Boundary Range: Warning Area And Stimulation Area - Num'axes CANIFUGUE Pro Manual De Instrucciones

move the magnetic key towards the collar so that it comes into contact with the area where the magnetic switch is located (ref.
Diagram 5).
The collar will emit 1 beep sound and the indicator light goes from flashing to permanent green then goes out indicating the collar is Off.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long period.
If your dog needs to leave the authorized area, you have to remove the collar or deactivate the transmitter by disconnecting it from the power supply.

CANIFUGUE MIX receiver collar

Contact points
(short or long)
as soon as the battery is in place, the collar is ready for use.
To fit the battery in the collar, proceed in the following way:
− Unscrew the 4 screws of the battery cover using a screwdriver.
− Insert the battery (3V Lithium CR2) paying attention to follow polarity indicated on the battery housing (ref. Diagram 6).
− A beep sound is emitted indicating the collar is ready for use. If you do not hear any beep sound after having inserted the battery, remove it imme-
diately from its housing. Check the polarity before trying again.
− Before putting the lid back in place, check that the rubber seal is in its groove.
− Retighten moderately the 4 screws.
if you wish to turn the collar Off, you should remove the battery from its housing.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long period.
If your dog needs to leave the authorized area, you have to remove the collar or deactivate the transmitter by disconnecting it from the power supply.

Adjusting the boundary range: warning area and stimulation area

Adjustment buttons on the transmitter enable you to increase or decrease the width of the warning and stimulation zones depending on the configu-
ration of your yard and how the wire is laid.
First of all, select on the transmitter the position of the small/large ground selector according to your ground:
- If you need less than 300 meters of antenna wire: select "small ground", by pushing the selector button to the left. The following pictogram appears
on the LCD screen:
- If you need more than 300 meters of antenna wire: select « large ground », by pushing the selector button to the right. The following pictogram
appears on the LCD screen:
WARNING: The choice of the selector's position is not determined by the wire length only, it also depends on the ground configuration.
Example: if you need more than 300 meters of antenna wire but the width of your yard is small, you will have to select "small ground".
The width of the warning zone is adjustable by using the
The stimulation zone is adjustable by using the
Diagram 6 CANIFUGUE MIX collar
Stimulation level
adjustment button
(modes)
and buttons located on the front of the transmitter (40 levels).
button located on the front of the transmitter (8 levels).
Gb - 19
Battery position