- Put battery cover back in place.
- Retighten the screw.
- Check the remote control operates correctly.
Diagram. 6
Replacing batteries
of CANICOM 1000
WARNING
Make sure the polarity is correct
Checking/Replacing battery of receiver collar
To check the condition of the receiver collar battery, observe the On/Off indicator located on the front
of the receiver collar:
• Battery fully charged: flashes slowly green.
• Weak battery: flashes quickly red. Replace it with a new battery 3-V Lithium CR2 (See § Fitting the
battery in the receiver collar). Check the receiver collar operates correctly.
Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are
inadequate, remove and replace them with the long ones supplied with the kit. Carefully tighten them
manually (do not use a key).
All manuals and user guides at all-guides.com
Gb - 22