Charging The Battery - Alcatel Onetouch POP 3 5.5 Manual De Instrucciones

Installing or removing the microSD card
To install, please open microSD card lock first, and then place the microSD
card into the slot with the gold contact facing downwards. To remove the
external microSD card, please open microSD card lock and take it out
from the slot.
Before inserting/removing the microSD card, you should ensure the
phone is off, to protect it from corruption or damage. In addition,
regularly removing or inserting the SD card may cause the phone to
restart.

Charging the battery

Connect the battery charger to your phone and mains socket respectively.
• Make sure the battery is correctly inserted before connecting the
charger.
• When using your telephone for the first time, charge the battery fully
(approximately 5 hours).
You are advised to fully charge the battery (
indicated by the percentage on screen while the phone is powered off. The
percentage increases as the phone is charged.
). Charging status is
19
If the battery is very low, there will be no indication that power is
being received until the charge is sufficient to show the charging
status bar. To reduce power consumption and energy waste, when
battery is fully charged, disconnect your charger from the plug; switch off
Wi-Fi, GPS, Bluetooth or background-running applications when not
in use; reduce the backlight time, etc.
1�2�2 Power on your phone
Hold down the Power key until the phone powers on, unlock your phone
(Swipe, PIN, Password and Pattern) if necessary and confirm. The Home
screen is displayed.
If you do not know your PIN code or if you have forgotten it, contact your
network operator. Do not leave your PIN code with your phone. Store this
information in a safe place when not in use.
Set up your phone for the first time
The first time you power on the phone, you should set the following
options:
• Select the phone's language, then touch
• Select an enabled Wi-Fi then touch NEXT, otherwise touch SKIP�
• Set up Google Services by marking the corresponding checkboxes, touch
MORE to learn more about Google Services, then touch NEXT.
• Set up Location service after switching the toggle for Location, then
select the desired location mode.
• Touch FINISH to complete the setup process.
Even if no SIM card is installed, your phone will still power on and you will
be able to connect to a Wi-Fi network, (refer to section "6�1�2 Wi-Fi"),
sign into your Google account and to use some features.
.
20