Speaker Distance - JVC KD-AVX2 Manual De Instrucciones

Indications
Speaker Level

Speaker Distance

* 1 When activating the test tone, white noise comes out and cycles between the speakers activated on
"Speaker Size" [35] for about 2 seconds each. Press 5 / ∞ repeatedly while the test tone comes out
from the target speaker to adjust the settings (the test tone continues to come out from the target
speaker during the adjustment).
* 2 The setting is effective only when a multi-channel source is played back and Disc Surround is on, or
when Dolby PLII Movie/Music is in effect. Adjust the level on "Subwoofer" [39] for other cases.
* 3 Selectable only when DISC is the source.
* 4 Unselectable when all the speakers other than front ones are deactivated on "Speaker Size" [35].
36
Selectable settings, [reference page]
*1
You can adjust the output level of each speaker monitoring
the test tone.
Press and hold ENT to activate (or cancel) the test tone.
• Front Lch/Center ch/Front Rch/Rear Rch/Subwoofer*
/Rear Lch: adjust the output level of each speaker in the
range of –10dB –+10dB. [Initial]; 00dB
Selects the speaker to adjust
*4
You can adjust the speaker output timing separately for each
speaker according to the distance from the speakers to the
listening position.
• Front Lch/Center ch/Front Rch/Rear Rch/Rear Lch:
adjust the speaker distance in the range of 15 cm (6 inch) to
600 cm (240 inch) in 15-cm (6-inch) step.
* Pressing and holding DISP (D) changes the measuring
unit between "cm" and "inch" alternately.
[Initial]; 120 cm (for center speaker), 150 cm (for the other
speakers)
Selects the speaker to adjust
Adjusts the speaker level
Selects the speaker to adjust
Adjusts the speaker distance
Selects the speaker to adjust
2