BaByliss for MEN E763XDE Manual Del Usuario página 8

USING THE CUTTING GUIDES
Very practical, the cutting guide
guarantees equal cutting length.
IMPORTANT: Always attach the
cutting guide BEFORE turning the
trimmer on, and turn it off before
changing the guide.
To attach the cutting guide,
first adjust the cutting length to
3mm or 21mm and place it on
the support guide adjusting first
both sides and then pushing on
the bottom of the guide until you
hear a 'click' . (Fig. 2)
To remove the cutting guide, first
adjust the cutting length to 3mm
or 21mm and push the guide out
of the support lifting it up with
your thumb. (Fig. 3)
NOTE: The precision guide must
be placed like the cutting guides
but it is adjusted manually and
independently of the grooved
wheel.
TURNING ON AND USING
To adjust the clipper's cutting
length, turn the grooved wheel
(7) up or down.
The selected length is displayed
on the right or left side of the
clipper.
Switch the ON/OFF button.
You can change the cutting length
at any time.
Thanks to the SMART ADJUSTING
SYSTEM, the length of the cut is
maintained even if the angle of
the clipper varies, so it guarantees
precise result.
CUTTING TECHNIQUES
ADVICE FROM THE EXpERTS
• Use the clipper on clean, dry
hair.
• To familiarize yourself with the
clipper, begin with the cutting
guide for a longer cut, then, if
you want a shorter cut, adjust
it by pushing the knob. You will
soon know the lengths of each
guide and each position.
• Always move the clipper against
the direction of hair growth.
• Begin at the nape. Place the
guide on the scalp and move the
clipper toward the crown of your
head. Move your clipper slowly,
pointing the teeth of the guide
slightly upward. Keep the clipper
in contact with your head at all
times. (Fig. 4)
• For the crown of the head, move
from front to back, that is, from
your forehead to the crown of
your head.
• For the finishing touches, that is,
around the nape and sideburns,
use the clipper without a cutting
guide. Turn your clipper over
and move it from top to bottom.
(Fig. 5)
• If you want a length greater than
30 mm, or if you are experienced,
you can create 'comb' or 'finger'
cuts:
- Work without a cutting guide.
- Take up a small section of hair
with a comb or in your fingers.
- Move the comb or your fingers
along the section of hair to the
desired length.
8
AND