Connection; Delivery Of The Material; Complaints; Primary Connection And Installation - Stel TIG μP 203H-353H AC/DC Manual De Instrucciones

ENGLISH
TIG µP 203H-353H AC/DC
COD. 6902500070

3.0 CONNECTION

3.1 DELIVERY OF THE MATERIAL

The package contains:
- N°1 generator Cod. 605340000L TIG µP 203H AC/DC
Cod. 605320000L TIG µP 353H AC/DC
- N°1 instructions manual Code 6902500070
- N°1 Earth cable Code 602030000L
- N°1 Setting up Kit Code 608020000L
Check that all the material listed above is included in the package. Inform your distributor if anything is
missing. Check that the generator has not been damaged in transport. If you see any sign of damage,
consult the COMPLAINTS section (Par. 3.2) for instructions. Before working with the generator read this
instructions manual carefully.

3.2 COMPLAINTS

Complaints for damage during transport: If your equipment is damaged during transport, send a
complaint in writing to the carrier.
Complaints for faulty goods: All the equipment shipped by STEL SRL has been subjected to strict
quality control. However, if your equipment does not work correctly, consult the TROUBLESHOOTING
section in this manual. If the fault persists, consult your authorized dealer.
3.3 PRIMARY CONNECTION
INSTALLATION
WARNING: This Class A equipment is not intended for use in residential locations where the
electrical power is provided by the public low-voltage supply system. There may be potential difficulties in
ensuring electromagnetic compatibility in those locations, due to conducted as well as radiated disturbances.
This equipment does not comply with IEC 61000-3-12. If it is connected to a public low voltage system, it
is the responsibility of the installer or user of the equipment to ensure, by consultation with the distribution
network operator if necessary, that the equipment may be connected.
The good operation of the generator is ensured by correct installation; you must therefore proceed as
follows:
- Position the machine in such a way that there is no obstacle to the air circulation ensured by the internal
fan (the internal components require suitable cooling) (see chap. 7.1 page 33) .
- Ensure that the fan does not send deposits or dust into the machine.
- Avoid impacts, rubbing, and - absolutely - exposure to dripping water, excessive heat sources, or any
abnormal situations.
MAINS VOLTAGE
The generator works at mains voltages differing by 20% from the rated mains value of 400V (Minimum
voltage 320V, maximum voltage 480V).
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail:stelgroup.com
http: www.stelgroup.it
TECHNICAL
DESCRIPTION
43
ENGLISH
TIG µP 203H-353H AC/DC
COD. 6902500070
3.0 CONNECTION
3.1 DELIVERY OF THE MATERIAL
The package contains:
- N°1 generator Cod. 605340000L TIG µP 203H AC/DC
Cod. 605320000L TIG µP 353H AC/DC
- N°1 instructions manual Code 6902500070
- N°1 Earth cable Code 602030000L
- N°1 Setting up Kit Code 608020000L
Check that all the material listed above is included in the package. Inform your distributor if anything is
missing. Check that the generator has not been damaged in transport. If you see any sign of damage,
consult the COMPLAINTS section (Par. 3.2) for instructions. Before working with the generator read this
instructions manual carefully.
3.2 COMPLAINTS
Complaints for damage during transport: If your equipment is damaged during transport, send a
complaint in writing to the carrier.
Complaints for faulty goods: All the equipment shipped by STEL SRL has been subjected to strict
quality control. However, if your equipment does not work correctly, consult the TROUBLESHOOTING
section in this manual. If the fault persists, consult your authorized dealer.
3.3 PRIMARY CONNECTION
INSTALLATION
WARNING: This Class A equipment is not intended for use in residential locations where the
electrical power is provided by the public low-voltage supply system. There may be potential difficulties in
ensuring electromagnetic compatibility in those locations, due to conducted as well as radiated disturbances.
This equipment does not comply with IEC 61000-3-12. If it is connected to a public low voltage system, it
is the responsibility of the installer or user of the equipment to ensure, by consultation with the distribution
network operator if necessary, that the equipment may be connected.
The good operation of the generator is ensured by correct installation; you must therefore proceed as
follows:
- Position the machine in such a way that there is no obstacle to the air circulation ensured by the internal
fan (the internal components require suitable cooling) (see chap. 7.1 page 33) .
- Ensure that the fan does not send deposits or dust into the machine.
- Avoid impacts, rubbing, and - absolutely - exposure to dripping water, excessive heat sources, or any
abnormal situations.
MAINS VOLTAGE
The generator works at mains voltages differing by 20% from the rated mains value of 400V (Minimum
voltage 320V, maximum voltage 480V).
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail:stelgroup.com
http: www.stelgroup.it
TECHNICAL
DESCRIPTION
43