Connection; Receiving The Material; Complaints - Stel HI-MIG 353/503S-P 400V 3F Manual De Instrucciones

ENGLISH

3.0 - CONNECTION

3.1 - RECEIVING THE MATERIAL

The package contains:
- N°1 current generator for welding
- N°1 instructions manual
- N°1 setting up kit
- N°1 MIG air filter kit
- N°1 package
- N°1 MIG pin kit
- Earth cable
Check that all the material listed above is included in the package. Notify your
distributor if anything is missing. Ensure that the generator has not been damaged
during transport. If there is any visible damage, see the COMPLAINTS section (Par.
3.2) for instructions. Read this instructions manual carefully before working with the
generator.

3.2 - COMPLAINTS

Complaints for damage during transport: If your equipment is damaged during
transit you must present a claim to the carrier.
Complaints for faulty goods: All the equipment shipped by STEL is subjected
to strict quality control. However, if your equipment does not work properly, consult
the TROUBLESHOOTING section of this manual. If the fault persists, consult your
authorised dealer.
3.3 - PRIMARY CONNECTION
INSTALLATION
WARNING: This Class A equipment is not intended for use in residential
locations where the electrical power is provided by the public low-voltage supply
system. There may be potential difficulties in ensuring electromagnetic compatibility
in those locations, due to conducted as well as radiated disturbances.
This equipment does not comply with IEC 61000-3-12. If it is connected to a
public low voltage system, it is the responsibility of the installer or user of the
equipment to ensure, by consultation with the distribution network operator if
necessary, that the equipment may be connected.
The good operation of the generator is ensured by correct installation; you must
therefore proceed as follows:
- Position the machine in such a way that there is no obstacle to the air circulation
ensured by the internal fan (the internal components require suitable cooling) (see
chap. 6.1).
- Ensure that the fan does not send deposits or dust into the machine.
- Avoid impacts, rubbing, and - absolutely - exposure to dripping water, excessive
heat sources, or any abnormal situations.
MAINS VOLTAGE
The generator works at mains voltages differing by 20% from the rated mains value
of 400V (Minimum voltage 320V, maximum voltage 480V).
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
HI-MIG 353/503S-P 400V 3F
COD. 6907900030
TECHNICAL DESCRIPTION
HI-MIG 353 S-P
Cod. 608830000L
Cod. 6907900030
Cod. 606180000L
Cod. 605990000L
Cod. 6707700000
Cod. 606550000L
Cod. 607010000L
HI-MIG 503 S-P
Cod. 609210000L
Cod. 6907900030
Cod. 606180000L
Cod. 605990000L
Cod. 6707700000
Cod. 606550000L
Cod. 607010000L
39