Safety Instructions - YATO YT-85481 Manual Original

DEVICE CHARACTERISTICS
A power generator is an electromechanical device, in which
mechanical energy is converted into electrical energy. A gen-
erator consists of an internal combustion engine and a electric
generator that cooperate. The correct, reliable, and safe opera-
tion of the device depends on its proper use, so:
Read and keep the entire manual before the fi rst use of
the device.
The supplier shall not be held liable for any damage resulting
from failure to observe the safety regulations and recommen-
dations specifi ed in this manual.
ACCESSORIES
The generator is sold complete and does not require assembly,
however, it is necessary to carry out preparatory activities de-
scribed further in this manual. A spark plug wrench is supplied
with the generator.

SAFETY INSTRUCTIONS

General safety instructions
Protect children by keeping a safe distance from the generator.
The fuel is explosive and ignites easily. Do not refi ll fuel while
the generator is running. Do not smoke while refi lling. Do not
refi ll fuel nearby fl ames.
Do not spill fuel.
Fuel vapours are hazardous, and fuel preparation and refi lling
must be carried out in well-ventilated areas.
Some parts of the internal combustion engine can be hot and
cause burns. Pay attention to the warnings placed on the gen-
erator.
The generator must only be carried using the appropriate han-
dles. Do not touch the generator surface if it becomes hot dur-
ing operation, this may cause burns.
Fumes and exhaust gases are toxic. Do not use the generator
in rooms without ventilation. When used in ventilated rooms,
additional measures must be taken to prevent fi re and explo-
sion. When using the generator outdoors, ensure that it is not
positioned near windows, doors or ventilation inlets. Exhaust
fumes can enter the room and cause a hazard.
Read the warning labels and symbols placed on the generator.
Check their meaning with the operating manual.
Electrical Safety
Check the generator and the electrical accessories (including
plugs and cables) before use and make sure that they are not
damaged.
The generator is not intended to be connected to any other
source of electrical energy. It is absolutely forbidden to connect
the generator to a 230 V / 50 Hz mains socket.
Protection against electric shock depends on functioning of the
fuse specially selected for the generator. If the fuse needs to be
replaced, it shall be replaced with a fuse having the same rating
and performance characteristics.
Due to high mechanical stresses, fl exible cables with hard rub-
ber insulation (according to IEC 60245-4) or equivalent must
O R I G I N A L
12
GB
be used.
When using extension cords, make sure that they are suitable
for outdoor use. The resistance of the extension cables shall
not exceed 1,5 Ω. The total length of the cable must not exceed
60 m for a cable cross-section of 1.5 mm
cable cross-section of 2.5 mm
The generator is equipped with an electrical separation protec-
tive device and, therefore, its grounding is not required.
However, if the grounding is to be carried out, the installation
must be carried out by a qualifi ed electrician in accordance with
local regulations for the grounding of electrical equipment.
Warning! The location of use of the generator may be subject to
local restrictions. Observe the local electrical safety regulations
when using the generator.
Warning! The operator must observe the requirements and
precautions when retrofi tting the generator, depending on the
existing protective measures in the plant and the applicable
regulations.
Do not overload the generator. Most electrical equipment con-
sumes more power than its rated power during start-up. The
generator is not intended to power welders.
The power exceeding the rated power of the generator, but not
exceeding the maximum power, may not be used for more than
15 minutes.
It is not recommended to use splitters connected to the gen-
erator socket. However, if such devices are used, the power
demand of all consumers connected to the generator must be
summed up. The sum of the power demand of the consumers
must not exceed the rated power of the generator.
Operational safety
The generator must stand on a fl at, level, hard and stable sur-
face. Provide at least 1 meter of free space around the gener-
ator when it is running.
The generator must reach its rated engine revolutions before
connecting the electrical consumer. Before switching off the
generator, turn off the electrical consumer, if the consumer has
moving parts, wait until they have come to a complete standstill
and then unplug the consumer's power cord from the generator
socket.
The maximum engine's speed of revolution must not be ex-
ceeded. If the maximum engine's speed of revolution is ex-
ceeded, the generator can be damaged and operators can be
injured.
The generator must not be stored or used in a damp or electri-
cally conductive environment (e.g. on metal surfaces).
Do not expose the generator to precipitation. Do not use a gen-
erator that is exposed to precipitation.
The generator is not intended for use in potentially fl ammable
or explosive atmospheres.
The gases and exhaust fumes are hot enough to ignite certain
materials. Do not use the generator near combustible mate-
rials.
The generator must not be used if any damaged or destroyed
parts are noticed.
Do not leave the generator in operation unattended or under
the care of minors or persons who have not been trained in the
operation of the device.
The generator must be switched off immediately if the following
symptoms are noticed:
- changes of the engine's speed of revolution,
I N S T R U C T I O N S
, and 100 m for a
2
.
2