Cequent Performance Products 4484 Instrucciones De Instalación página 6

WARNING The fuel tank and/or other vehicle components are located below some of the holes. A wood or metal shield must be
placed between the frame and the fuel tank to prevent puncturing the fuel tank when the drill breaks through the bed.
7. For 6300/630044 & 8339 use outer edges of the long slots in the forward cross member as a template to
drill 5/8" diameter holes through the truck bed as shown in Figure 4. Not all holes can be drilled from
under the vehicle, but will be done later from inside the bed. Prime and paint raw metal.
8. Align the holes on the template (provided with gooseneck hitch) with the hole previously drilled
through the bed. Be sure that the template is properly oriented toward the front of the vehicle. Center
punch the holes that will be use to cut the opening in the bed. If the vehicle is equipped with a bed liner,
a section of the bed liner must be cut away so that the gooseneck hitch can contact the bed corrugations.
6300/630044/8339
Hole Locations
9. Drill 1/4" pilot holes (size will depend on width of blade in saber saw).
10. Cut out the truck bed. File edges, prime, and paint as needed.
11. Install hitch into opening.
12. Before installing the forward 5/8" carriage bolts through the hitch, two U-block shims (Part Number 5971)
must be placed between the hitch and the bed or the bed and cross member, which ever gives best support
to the bolts. These shims are necessary to prevent the bed corrugations from collapsing when the bolts are
tightened. Shims with isolator tape towards bed.
13. Using the hitch as a guide to drill the 5/8" diameter mounting holes through the bed and aligning with the
slots in the rearward cross member. Also drill 5/8" diameter U-Bolt holes through the bed using the holes in
the hitch as a template. Prime and paint raw metal.
2014, 2015 Cequent Performance Products
©
Installation Instructions
Gooseneck Mounting Kit
Insert forward cross member and
slide forward
Use outer edges to drill
5/8" holes here
Template p/n 5978 for use with 6300/630044 head
Template p/n 114234 for use with 8339 head
A durable and reusable stainless steel templates is
available. A time saver for cutting bed liner and bed.
Template p/n 6425 for use with 8339 head
Printed In Mexico
Ford F-150
Figure 5
Forward cross
Rearward cross
Figure 4
Sheet 5 of 6
Part Numbers:
Insert rearward cross member
member
member
4484N 5-12-15
4484
Rev. C