Kit Purpose - Volvo Penta 3861803 Instrucciones De Montaje

Kit Purpose

This kit is designed to allow installation of a
digital trim instrument in a boat originally
equipped with a analog trim instrument for
the SX transom shield.
Kit Contents
3852555 Retainer
3857362 Cable Kit
3858212 Trimming Indicator
3858773 Trimmer
Kit Installation
Refer to the diagram included in the back of this
instruction for gauge and cable installation and
connections.
Warning! Disconnect electrical power
before beginning any work on the electrical
system.
2
1
1
1
TRIM SENDER REMOV V V V V AL TRIM SENDER REMO TRIM SENDER REMO
TRIM SENDER REMO TRIM SENDER REMO
Disconnect rubber connector at wiring harness on
engine. Record the position of the sending unit wires
before removing. Use Socket Removal Tool, Volvo
Penta P/N 3854350-0 to push terminals out of rubber
plug.
Note! The use of alcohol will make socket
installation into the rubber plug easier.
Remove the retaining clip from the grommet
Push the grommet out with a screwdriver. Pull the
wires through the hole, cut tie straps securing wires
to the trim/tilt lines, and remove the trim sender.
AL AL AL
AL
E .
5