Set-Up Procedures - Kinetico POWER LINE Pro Serie Manual Del Usuario

Set-up Procedures

System Adjustments Using Push Button/Display Interface
NOTE: Changing any setting could affect the operation of your system. Consult your local
dealer before making any adjustments
Main Menu
12:00
1. To enter Main Menu, press the Menu/Enter button. (Time of Day will flash.)
2. To set the Time of Day, press the Set/Change button. (First digit will flash.)
( 12:00)
Example
- To change digit value, press the Set/Change button.
- To accept the digit value, press the Menu/Enter button.
- Next digit will flash to begin setting.
- Once the last digit display is accepted, all digits will flash.
3. To set A.M. or P.M., press the Menu/Enter button.
- To change digit value, press the Set/Change button. Example
- To accept the digit value, press the Menu/Enter button.
- Once A.M. or P.M. is accepted, the next menu item will flash.
4. To set the Days Between Backwash
- Press Menu/Enter Button. This display is used to set the maximum amount of
time (in days) the unit can be in service without a backwash. This option setting is
identified by the letter 'A' in the left digit. Backwash will begin at the set Backwash
Time. A "0" setting will cancel this feature. The maximum value for this item is 29.
Example: Backwash every 7 days
To adjust this value press the Set/Change button.
To accept the digit value press the Menu/Enter button.
5. To set the Number of Days between Air Draw Cycles (d), press the Set/
Change button.
NOTES:
6. To Exit Main Menu, press the Menu/Enter button.
NOTE: If no buttons are pressed for 60 seconds, the Main Menu will be exited
6
Cancel setting
Repeat instructions from step 2. Example
1) Maximum value is 9.
2) If value is set to 0, air draw is turned off, but an air cycle will still
be completed when backwash cycle occurs. If the Number of
Days between Air Draw Cycles is set to a higher number of days
than the Number of Days between Backwash Cycles, it will have
no effect. In order to turn off all cycles, both the Days between
Backwash and Days between Air Draw Cycles must be set to 0.
3) Default setting is 1 day.
automatically.
MENU / ENTER
SET / CHANGE
(A-07)
(Factory Setting)
(A-00)
BUTTON
BUTTON
(A)
(d-01)