Normal Operation - Kinetico POWER LINE Pro Serie Manual Del Usuario

System Adjustments Using Smart Phone/Tablet Interface
NOTE: Changing any setting could affect the operation of your system. Consult your local
dealer before making any adjustments
To take advantage of the bluetooth interface, this feature must be set up on
compatible Bluetooth-enabled smart phones or tablets.

Normal Operation

Battery Backup (Uses a standard 9-Volt alkaline battery.)
Features of Battery Backup:
•
During power failures, the battery will maintain the time of day as long as the
battery has power. The display is turned off to conserve battery power during
this time. To confirm that the battery is working, press either button, and the
display will turn on for five (5) seconds.
• If power failure occurs while system is regenerating, the Kinetico Powerline
PRO Filter will motor to a shut off position to prevent constant flow to drain.
After power is restored, the Powerline PRO Filter will return and finish the
cycle where it left off prior to the power interruption.
• When used without battery back-up, during a power failure, the unit stops at
its current point in the regeneration position and then restarts at that point
when the power is restored. The time will be offset by the increment of time
the unit was without power, so it is necessary to reset the time of day on the
unit. No other system settings will be affected.
Starting Extra Regeneration Cycle
1. To Start Delayed Extra Cycle Example
- If Days Remaining Until Next Regeneration does not read '1,' press and hold the
Set/Change button for 3 seconds until the display reads '1.'
- Regeneration cycle will initiate at the next designated regeneration time.
2. To start Immediate Extra Cycle
- Press and hold the Set/Change button.
- After 3 seconds, the regeneration cycle will begin.
3. To Fast Cycle thru regeneration
- Press and hold the Set/Change button for 3 seconds to advance to the next cycle
step.
NOTE: Fast Cycle is not necessary unless you want to manually step through each
cycle step.
(Repeat until valve returns to the home display - time of day.)
Air-Activated Powerline PRO Filter
[ 1]
First complete above step.
First complete above 2 steps.
7