THOMSON MIC120DABBT Modo De Empleo página 21

For MP3 disc:
1. Press / to select an album or a folder.
2. Press /
3. Press the [VOL+/VOL-] to adjust the volume.
USB
Reduce the volume and connect the USB device to the USB port.
Hold the main unit when connecting or disconnecting the USB device.
1. Press [SOURCE] repeatedly to select "USB". The USB will play automatically.
2. Press the /
3. Press the [VOL+/VOL-] to adjust the volume.
Bluetooth®
You can connect and play an audio device wirelessly through Bluetooth®
Preparation
• Switch on the Bluetooth® feature of device and put the device near the system.
• Read the device's operating instructions for details.
1. Press [SOURCE] repeatedly to select the Bluetooth mode; ''PAIRING" blinks,
2. Select "MIC120DABBT/MIC122DABBT/MIC125DABBT" from the Bluetooth menu of the device.
If prompted for a passkey, input "0000".
The device connects with this system automatically after pairing is complete.
The name of the connected device is shown for a few seconds.
3. If this system is connected to a Bluetooth device, press and hold
is shown.
4. Start playback on the device.
5. Press or
6. Press [VOL+/VOL-] or rotate the VOLUME knob to adjust the volume.
Audio in
You can play music from an external audio device such as an MP3 player through this unit.
Line in Jack (Requires a 3.5mm cable)
1. Connect a 3.5mm cable to the Line in jack on the top panel. Connect the other end of the 3.5mm
cable to an MP3 player or other audio device.
2. Press the [SOURCE] button repeatedly to select Line In mode.
3. Use the controls on the connected device to begin playing audio.
DAB radio
Carefully extend the telescopic aerial
Auto scan
1. Press [SOURCE] to select "DAB MODE".
If this is the first time the unit has gone into DAB Mode, it will automatically start an 'Auto Scan'
to search for available stations. (Once DAB mode has been used before, the MIC120DABBT/
MIC122DABBT/MIC125DABBT will automatically select the previously played station)
2. Press the [ENTER] key. It will automatically start auto scan to search for available stations.
During the scanning process, the lower line of the display shows a bar-graph indicating the
progress of the scan.
Manual scan
1. Press [SOURCE] on the main unit to select "DAB MODE".
2. Press or
selection.
to select a track or a file.
to select the folder. Press the
to skip tracks.
to select "Manual tune". Press the [ENTER] key to access the DAB frequency
/ to select a track.
- EN 7 -
to disconnect it, until [NO BT]