Clock And Timers - THOMSON MIC120DABBT Modo De Empleo

Clock and timers

Setting the clock
After the unit is plugged into a mains supply or following a mains power failure, the display will show
"0:00" on the LCD display. The unit should be in standby mode to set the current clock.
1. Press the [TIME] button. The digits for the display will blink.
2. Press the / button repeatedly until the correct hour is set. Press [ENTER] to confirm the hour
setting.
3. The minute digits on the display will blink.
4. Press the /
minute setting.
Setting the alarm
This unit can be used as an alarm clock. The Bluetooth device, USB and FM are activated to play at
a preset time.
1. Press to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press the [ALARM] button in shutdown mode. The display will flash ON to select alarm setting,
and the display will blink.
4. Press [ENTER] to confirm. The time display will blink.
5. Press the /
6. Press / to set the minutes.
7. Press [ENTER] to confirm, and then press
to confirm.
8. The volume turns up from 0 to 20 gradually.
9. Press the [ALARM] button in shutdown mode. The display will flash ON to select the alarm setting,
and the display will blink.
10. Press / to select OFF to cancel the alarm.
Snooze
1. Press to set the alarm; it re-sounds after 9 minutes.
Sleep timer
1. Press the [SLEEP] button. The display will blink. Press the button until the display shows the
minute you want to set. You can set 90/60/45/30/15 minutes.
2. It blinks three times to confirm, and then returns to the previous interface. If you want to cancel the
sleep mode, press OFF. After blinking three times, sleep mode will cancel.
Playing the media
Disc
Play a disc
1. Press [SOURCE] repeatedly to select DISC
source.
2. Insert a disc with the printed side facing upward.
3. Play starts automatically, if not, press
4. Press the [VOL+/VOL-] to adjust the volume.
Pause / resume play
• During play, press
• During play, long press the
Skip to a track
For CD:
1. Press /
2. Press the [VOL+/VOL-] to adjust the volume.
button repeatedly until the correct minute is set. Press [ENTER] to confirm the
button repeatedly to set the hour. Press [ENTER] to confirm.
to pause/resume play.
/ button to fast forward/rewind.
to select another track.
/ to select CD/DAB/FM/USB status. Press [ENTER]
.
- EN 6 -