Installation And Setup; Instructions On Unpacking; Customer Service Assistance; Shipping Container Information - DenMat SOL Instrucciones De Uso

f insTAllATiOn AnD sETUP
InsTruCTIons on unPaCkIng &

CusTomer servICe assIsTanCe

A DenMat customer service representative or dealer
can provide assistance when you are ready to remove
the SOL Laser from its shipping container. Please do
not attempt to unpack the SOL Laser and install or
setup the unit without reading this manual first. If you
are unsure about any aspect of the assembly, call your
DenMat customer service representative or dealer for
assistance.

sHIPPIng ConTaIner InformaTIon

The shipping container you received with your SOL Laser
was specially designed to safely transport the laser. In the
unlikely event that you need to return the laser for service
or repair, please retain the original shipping container.
ConTenTs of sol laser
sHIPPIng ConTaIner:
The contents of the shipping container should
include the following:
•
SOL Diode Laser System with Handpiece and Optical Fiber
•
SOL Foot Switch
•
AC/DC Power Converter
•
Laser Operating Key
•
Fiber Optic Tips, 400 Micron/5 pc
•
Single-use Barrier Sleeves for Handpiece 25 pc
•
Protective Glasses 3 pc
•
Safety Sign
•
SOL Laser Instructions
•
Warranty Information
•
Extended Warranty Offer
•
Online Training Offer
•
Battery Charging Notice
Each of the items listed above should be inspected and the
instructions followed. Use of any cables or accessories not
supplied with the system, or by DenMat, may damage the
system and will void the warranty.

laser Hand PIeCe and fIber

NOTE: Avoid Exposure–Laser Radiation is emitted from this aperture.
The detachable hand piece and fiber are installed and ready
for use at the time of shipment. Uncoil the fiber and install a
SOL procedure tip into the hand piece. Proper use of
the system tips and fiber replacement is explained later in
this manual.

fIber WraP

(Fig. 3.0)
A fiber wrap is provided to protect and store the system
fiber when not in use. Gently extend the fiber by
unwrapping clockwise and return in the counterclockwise
direction. TO AVOID DAMAGE TO THE FIBER, do not
bend at sharp angles or in a radius smaller than the internal
diameter of the fiber wrap.

key sWITCH

(Fig. 4.1)
A removable key switch is provided as a safety feature to
prevent the unauthorized operation of the laser. It is the
responsibility of the laser safety officer to maintain control
of the key switch and store it in a secure location when
the laser is not in use. The key switch must be turned
clockwise to the ON position to power the system controls
and activate the laser.

aC/dC PoWer suPPly ConneCTor

USE MODEL FW7362M/12 ONLY. An external power
supply is provided for charging the system battery and an
alternate laser power source. During initial setup use the
AC/DC power supply for up to four hours to fully charge
the battery. Note the Battery Charge Level indicator (Fig 1,
Item 6) on the system control panel, flashes to confirm that
the power supply is connected and the battery is charging.
NOTE: battery does not charge when the system is in
the Ready Mode or during laser activation so Charge
Indicator does not flash. Plug the power supply into an
AC outlet and connect to the corresponding connector on
the rear of the system. Only use the SOL Power Supply.
Others may damage the system.

PoWer on/off sWITCH

The power switch is located on the rear of the system and
must be in the ON position for the laser to be operated.
Turn the power switch to the OFF position when the laser is
not in use.
(Fig. 2.0)
(Fig. 4.2)
(Fig. 4.3)
5 5