Publicidad
Step 12
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (F) and lay it over your unit.
Make equal margins along all four edges of the BACK (F).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHT (C).
Fasten three METAL BRACKETS (4G) to the SUPPORT (P).
å
Use three BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: Be sure the edges of the METAL BRACKETS are
å
even with the edge of the SUPPORT.
Fasten the SUPPORT (P) to the BOTTOM (E). Use three
å
BLACK 9/16" LARGE HEAD SCREWS (1S) through the
METAL BRACKETS and into the BOTTOM.
These holes must line up
over the UPRIGHT (C).
NAIL
(48 used for the BACK)
Page 16
1N
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
4G
F
E
P
BLACK 9/16" LARGE HEAD SCREW
(6 used for the SUPPORT)
P
4G
1S
Publicidad
