Publicidad
Step 13
1
D22
L
Groove
Insert the DRAWER SIDES (D22 and D23) at an angle
å
into the slot at each end of the DRAWER FRONT (L).
3
Minimum
190 degrees
M64
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M64) to the DRAWER
å
FRONT (L). Tighten one HIDDEN CAM.
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D23
Maximum
Arrow
210 degrees
L
VIEW THE T-LOCK BOX VIDEO
2
U n
fi n
s u
i s h
r f a
e d
c e
D22
L
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D977) into the
å
grooves in the DRAWER SIDES (D22 and D23) and
DRAWER FRONT (L).
4
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D22
M64
Fasten the DRAWER BACK (D68) to the DRAWER
å
SIDES (D22 and D23) and DRAWER BRACE (M64). Use
five BLACK 1-9/16" FLAT HEAD SCREWS (30S). Repeat
this step for the other DRAWERS. Use parts K, D26, D27,
D128, D977 and M64 for the small drawers.
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D977
D23
30S
(30 used in this step)
D68
Be sure the
DRAWER
D23
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 17
Publicidad
