Dash Disassembly; Kit Preparation - Metra 95-3009 Instrucciones De Instalación

DASH DISASSEMBLY

1. Remove (2) Phillips screws from the top
of the driver's side knee bolster.
2. Remove (2) 9/32" screws from the
bottom of the knee bolster.
3. Open the glove box, remove (3) 9/32"
screws exposed on the right edge of the
radio trim bezel and remove the bezel.
(Figure A)
4. Remove (2) 9/32" screws securing the
left side of the factory radio and (1)
10mm nut securing the right.
5. Slide the radio from the dash and
disconnect the wiring.
Continue to Kit Preparation
2
(Figure A)

KIT PREPARATION

1. Using a cutting tool, remove the section
of subdash indicated. (Figure A)
Continue to Kit Assembly
(Figure A)
|
1.800.221.0932 MetraOnline.com