aquatermic XK49 Manual Del Usuario página 18

Figure 3.11 Connection fashion 2 of Wired Controller and Gate Control
Note:
① Wired controller 2 in figure 3.11 can be set as master controller or slave
controller;
② Wired controller 1 in figure 3.11 can be model XK49 or other models.
(4) Power input of gate control card insertion/removal device supported by
wired controller: AC 100-240V~50/60Hz, DC 5~24V. In practice, connect
the gate control output power cord with the corresponding power supply
interface of wired controller according to the type of output power of
gate-control device (Please refer to 3.1.4 Installation for wire connection of
specific interface). Wired controller will judge the placing and absence of
card by detecting the power supply of gate-control device. The detecting
process is as follow:
15
Wired Controller XK49