Changing the fan speed
Changing the temperature
NOTE
Auto Changeover
• When in Auto Mode, the unit selects the operating mode (cooling, heating or fan only) based on the user set point
temperature.
• If the Auto mode is uncomfortable, you can select the desired conditions manually.
Cooling
• If there is a demand for cooling, unit will start approximately 1 minute after mode is selected.
Heating
• If there is a demand for heating, unit will start approximately 3 to 5 minutes after the mode is selected.
• After the heating operation has stopped, fan may continue to run for approx. 30 seconds.
• When the room temperature reaches the set temperature, the outdoor unit stops and the indoor unit fan runs at
extremely low speed.
• During defrost operation, the fan stops so that cool air is not discharged. ("
When restarting the operation after stop
When the unit is attempted to restart immediately after it was stopped, the unit can not start for approx. 3 minutes to
protect the compressor.
113-EN
1
Push the "
Fan speed" [
F2]
Fan speed
button to select the fan speed.
The fan speed changes as follows each time the
button is pushed.
Med +
Auto
High
Low +
Low
Med
"
" is not available when "Fan" is selected as
the operation mode.
1
∧
∨
Push the [
] / [
] button to adjust
the temperature.
∧
Push the [
] button to raise the
∨
temperature setting, push the [
] button
to lower it.
• For setting temperature range for each
operation mode, refer to the Set temp. range
limit on the separate Owner's Manual for remote
controller.
• The temperature cannot be adjusted when
"Fan" is selected as the operation mode.
Preparing to heat" icon is displayed.)
– 57 –
5
Off reminder timer
Before setting
Off reminder timer
1.Off reminder timer
ON / OFF
2.Timer setting
Set OFF
90 min.
Return
Fix
Off reminder timer
Set the length of time until the air conditioner stops automatically.
Off reminder timer
1.Off reminder timer
ON / OFF
2.Timer setting
Set OFF
90 min.
Return
Fix
Off reminder timer
1.Off reminder timer
ON / OFF
2.Timer setting
Set OFF
90 min.
Return
Fix
+
–
1
Push the [
MENU] button.
2
∧
∨
Push the [
] / [
] button to select
"4.Off reminder timer" on the menu screen,
then push the "
Set" [
F2]
Set
button.
1
∧
∨
Push the [
] / [
] button to select
"1. Off reminder timer".
2
Push the "
←
" [
F1] button.
→" [
Push the "
F2] button to
turn off the Off reminder timer.
3
∧
∨
Push the [
] / [
] button to select
"2. Timer setting".
4
Push the "
+" [
F1] / "
+
–
[
F2] button to set the time.
The time can be set at 10 minutes intervals.
5
Push the [
MENU] button.
The screen returns to the menu screen.
-"
114-EN