Energy Saving Operation - Toshiba RAV-RM561FT-EN Manual Del Propietário

7

Energy saving operation

Perform the power saving operation of the air conditioner.
Energy saving(1/2)
1.Energy saving operation
<ON>
2.Set temp. range limit
3.Return back
<OFF>
Return
Set
Energy saving operation
1.Energy saving operation
ON / OFF
2.Energy saving ratio
3.Energy saving schedule
Return Fix
119-EN
1
Push the [ MENU] button.
2
∧ ∨
Push the [ ] / [ ] button to select
"9.Energy saving" on the menu screen, then
push the " Set" [ F2] button.
Set
3
∧ ∨
Push the [ ] / [ ] button to select
"1. Energy saving operation" on the
"Energy saving" screen, then push the
" Set" [ F2] button.
Set
4
To start the Energy saving operation:
After setting "2. Energy saving ratio" and "3.
Energy saving schedule", push the
←
" " [ F1] button to select

"ON", then push the [ MENU] button.
To stop the Energy saving operation:
Push the " →" [ F2] button to

select "OFF", then push the [ MENU]
button.
Energy saving ratio
Carry out the setting operation while the indoor unit is stopped.
(Turn off the air conditioner before starting the setting operation.)
Energy saving operation
1.Energy saving operation
ON / OFF
2.Energy saving ratio
3.Energy saving schedule
Return Fix
Set
Energy saving ratio
Energy saving ratio
75%
Return Fix
% + % –
NOTE
• Cooling / heating performance may be reduced a little because its power is saved during the Energy saving operation.
• " " appears on the display when the Energy saving operation is activated.
• The Energy saving operation cannot be set on the sub remote controller when the two remote controller system is
used.
• For Energy saving schedule operation, refer to the separate Owner's Manual for remote controller.
• The remote controller may not be used for setting the Energy saving operation depending on the settings of the
central control remote controller or the outdoor unit.
• For "2. Set temp.range limit", "3. Return back", or "4. Saving operation", refer to the separate Owner's Manual for
remote controller.
– 60 –
1
∧ ∨
Push the [ ] / [ ] button to select
"2. Energy saving ratio" on the "Energy
saving operation" screen, then push the
" Set" [ F2] button.
Set
2
Push the " %+" [ F1] /
+
%
" %-" [ F2] button to set the
% –
value.
The Energy saving ratio can be set within the
range from 50% to 100% by 1 %. The lower the
value is set, the higher the power saving effect
becomes.
3
Push the [ MENU] button.
" Setting" appears on the screen, then the
screen returns to the "Energy saving operation"
screen.
120-EN