Optional Sub-Assemblies / Accessories En; Putting Into Operation - Abicor Binzel BRS-CC Instructivo De Servicio

5 Putting into operation

4.4 Optional sub-assemblies / accessories
Prism
Milling cutter
Solenoid valve (24 V DC)
Maintenance unit
Options / accessories
Tab. 13
5 Putting into operation
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair work, the following instructions
must be adhered to:
• Switch off the power supply and close off the compressed air supply.
• Close off the gas supply and pull the main plug.
NOTE
• The device may only be put into operation by trained personnel.
• Make sure that the cleaning process is not impaired by the collecting tray and the bottle holder.
This chapter gives you all the information that must be taken into account when putting the device into
operation.
EN - 9
Anti-twist fastening with cylinder head screw M5x20 in clamping device.
The milling cutter dimensions are determined based on the gas nozzle and torch geometry for an
immersion depth up to 50 mm. It can be delivered for all standard WH and robot torch versions
with nominal diameters from 13 to 19.
ID 832.0005
To air-blast the interior of the gas nozzle during cleaning.
ID 830.0075
Consists of a filter regulator and oiler.
The maintenance unit separates solid particles from the compressed air and adds atomised oil for
lubricating the pneumatically driven components.
DANGER
BRS-CC