GRAPHITE 58G046 Instrucciones De Uso página 17

Use the hexagonal key and loosen the blade holder (7) fixing screws (fig. A).
Slide blade to the blade holder (7) to mechanical stop (blade teeth should face forward).
Tighten the fixing screws with the hex key (fig. A).
Ensure the blade is properly fitted in the guide roller (6) (fig. A). Blade removal is similar to installation, only
the sequence of actions is reversed.
Use blades suitable for U or T shank holder mechanism, as shown on fig. C.
DUST EXTRACTION
To improve dust extraction from processed material surface, the jigsaw is equipped with own dust blow-off
system, which cleans the surface being cut. Additionally, it is possible to attach external dust extraction
system to the adaptor.
Slide adaptor (3) into the dust extraction outlet (4) and turn counter-clockwise to secure (fig. D).
Attach suction hose of the dust extraction system to the adaptor (3). Make sure the connection is
tight.
SWITCHING ON / SWITCHING OFF
Before connecting the jigsaw to a power supply always check that power supply voltage matches
rated voltage on the label fixed on the power tool.
Switching on – press the switch button (1) and hold in this position.
Switching off – release pressure on the switch (1).
Locking the switch (continuous operation)
Switching on:
Press the switch button (1) and hold in this position.
Press the switch lock button (2) (fig. E).
Release pressure on the switch button (1).
Switching off:
Press and release the switch button (1).
CONTROL OF JIGSAW OPERATION SPEED
You can control rotational speed of jigsaw motor by turning and setting the work speed control wheel (9)
in desired position. It allows to adjust the power tool working speed to match characteristics of processed
material. Speed control range is 1 to 6.
The bigger the number on the wheel rim (9) (fig. F), the greater the jigsaw operation speed.
FOOTPLATE ADJUSTMENT FOR BEVEL CUTTING
Disconnect the power tool from power supply.
Adjustable jigsaw footplate allows to make a bevel cut in the range from 0
UUse the hexagonal key and loosen the footplate (5) fixing screws.
Move the footplate (5) backwards and tilt right or left (up to 45
Set the footplate (5) at desired angle, move forward and tighten fixing screws to secure it (fig. H).
Scale allows for setting the footplate to angles: 0°, 15°, 30° or 45° (right or left). Always put the hexagonal
key in its storage place after adjustment has been made.
OPERATION / SETTINGS
17
0 to 45 0 (to either side).
0
).