Sauder 422032 Manual Del Usuario página 9

Step 4
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (M75) onto the ENDS (A
å
and B). Line up the grooves in the MOLDINGS over the
heads of the SCREWS in the ENDS.
NOTE: The MOLDINGS should be even on both edges of
å
the ENDS.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
A
B
BLACK 9/16" FLAT HEAD SCREW
BLACK 9/16" FLAT HEAD SCREW
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
M75
Shoulder
32S
32S
M75
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 9