Black 1-9/16" Flat Head Screw - Sauder 422032 Manual Del Usuario

Step 27
1
D14
Q
Groove
Insert the FILE DRAWER SIDES (D14 and D15)
å
at an angle into the slot at each end of the FILE
DRAWER FRONT (Q).
3
Be sure the FILE
DRAWER BOTTOM
inserts into the
FILE DRAWER
BACK groove.
Fasten the FILE DRAWER BACK (D151) to the FILE DRAWER SIDES (D14 and D15). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the FILE DRAWER BOTTOM (D953) inserts into the groove of the FILE DRAWER BACK (D151).
å
Repeat this step for the remaining drawer. Use the DRAWER FRONT (P), DRAWER SIDES (D10 and D11), DRAWER
å
BACK (D151), and DRAWER BOTTOM (D954).
Page 32
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D15
D151
D14
D953
2
D14
Be sure the FILE DRAWER
BOTTOM inserts into the FILE
DRAWER FRONT groove.
Slide the FILE DRAWER BOTTOM (D953) into the
å
grooves in the FILE DRAWER SIDES (D14 and D15) and
FILE DRAWER FRONT (Q).
D15
With the palm of your
hand, tap the DRAWER
BOTTOM down into
U n fi
n i s h
the groove.
s u r
e d
f a c
e
D953
D15
Q
Start each screw a few turns before
completely tightening any of them.
30S

BLACK 1-9/16" FLAT HEAD SCREW

(8 used in this step)