Gold 5/16" Flat Head Screw - Sauder 422032 Manual Del Usuario

Step 10
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (40MA) to the RIGHT END (A) and RIGHT
å
UPRIGHT (D). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
å
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to fi nd
the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the FILE DRAWER SIDES.
å
Push the black lever in and pull the SLIDE from the RAIL.
3S

GOLD 5/16" FLAT HEAD SCREW

(4 used in this step)
D
J
Open end
40MC 40MA
H
A
Open end
Page 15