Cobra GLOBE 4800 CAN Manual Del Usuario página 20

8 - PIN CODE PERSONALISATION
The PIN code should be personalized. As the PIN CODE
enables access to the system, it should not be left in the
unattended vehicle as it can be used to deactivate the system
or to add new radio controls without authorization. In case
of loss it is possible to replace the PIN CODE with the following
procedure, and it must be replaced by a four digit code without
the number '0'. Choose a code that you already use for other
purposes to remember more easily (mobile phone, credit card,
etc.). To program the system with your own four digit PIN
CODE, disarm the system then proceed as follows:
• open a door.
• turn the ignition On.
• push the button on the control panel for a number of times
corresponding to the first digit of the old PIN CODE. The
LED will blink everytime you press the button, a longer
blink will confirm that the right PIN CODE digit has been
input.
Proceed in the same way for all others digits. When the
code is recognized the turn indicators will blink once.
• you have 20 s to start again the old PIN CODE input: press
the button on the control panel for a number of times
corresponding to the first digit of the old PIN CODE. The
LED will blink everytime you press the button, a longer
blink will confirm that the right PIN CODE digit has been
input. If this PIN CODE is the same as the previous, the LED
goes on a fixed way for 3 s. When it goes off you can digit
the new PIN CODE.
GB
20
06DE2177B.pmd 20
• press the button on the control panel for a number of times
corresponding to the first digit of the new PIN CODE. The
LED will blink everytime you press the button, a longer
blink will confirm that the right PIN CODE digit has been
input.
• turn the ignition off.
• repeat the new code entry: press the button on the control
panel for a number of times corresponding to the first digit of
the new PIN CODE. The LED will blink everytime you press
the button, a longer blink will confirm that the right PIN
CODE digit has been input. If this PIN CODE is the same as
the previous the system will store it: The storage
confirmation is given by a 3 s blink of the turn indicators
and of the LED.
To exit the program at any time, close the opened door and
the old PIN will not be modified.
8.1 - Loss of the personal PIN CODE
In case of loss of the PIN CODE there is no possibility to enter
in the system and to program it again.
8 - PERSONAL PIN CODE
28/05/2007, 10.33
GLOBE 4800/4900 CAN