Airwell AW-DDV009-N11 Manual De Usuario E Instalacion página 18

Electrical Wiring
Dipswitch Setting
•The dipswitch is dialed to "ON" position with the overline at the state of strapping if the code
or overline status is "1" The dipswitch is dialed to "OFF"position with the overline at the state
of disconnection if the code or overline status is "0"
• In the table below, the choice in the box " " refers to the setting of the socket/overline before
delivery.
Indoor Units PCB
In the following table, 1 represents ON and 0 represents OFF.
Definition principles of code switches:
SWO1 is used to set capabilities of master and slave indoor units as well as indoor unit; SW03
is used to set indoor unit address (combine original communication address and address of
centralized controller); SW08 is used set room card and 26°C lock.
(A) Definition and description of SW01
Operatlon
mode
SW01_1 displayed
on wired
controller
Address
SW01_2 of wire
SW01_3 controlled
SW01_4 indoor unit
(Note 1)
SW01_5
SW01_6 Capability of
SW01_7 indoor unit
SW01_8
Note 1: A wired controller can connected to at most eight ultrathin air-duct indoor units.
1 [air supply] [refrigerating] [dehumidification]
0 [automatic] [air supply] [refrigerating] [dehumidification] [heating]
[2] [3] [4] Address of wire controlled indoor unit (group address)
0 0 0
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1
[5] [6] [7] [8]
0 0 0 0
0 0 0 1
0 0 1 0
0 0 1 1
0 1 0 0
0 1 0 1
0 1 1 0
0 1 1 1
1 0 0 0
1 0 0 1
1 0 1 0
1 0 1 1
1 1 0 0
1 1 0 1
1 1 1 0
1 1 1 1
0# (wire controlled master unit) (default)
1# (wire controlled slave unit)
2# (wire controlled slave unit)
3# (wire controlled slave unit)
4# (wire controlled slave unit)
5# (wire controlled slave unit)
6# (wire controlled slave unit)
7# (wire controlled slave unit)
Capability of indoor unit
15
0.6HP
0.8HP
1.0HP
1.2HP
1.5HP
1.7HP
2.0HP
2.5HP
3.0HP
3.2HP
4.0HP
5.0HP
6.0HP
8.0HP
10.0HP
15.0HP