B.A. International Optima EOS350 Instrucciones De Uso página 6

Extraoral Suction System, Instructions For Use and Installation
3) Before use
① Make sure the grounding connection is properly established.
② Make sure the electric wires are complete and properly connected.
4) During use
① Avoid continuous running of the equipment. The product is designed to be used on a per
patient basis.
② Continuously monitor equipment and patient for any irregularities.
③ Discontinue use of the product immediately in case of any irregularities that may arise in
the system or patient during use.
④ Patients should not be allowed to operate or handle the product.
5）After use
① Cut off the main power in the following order: re-press the start button, turn off the power
switch, and disconnect the power cord.
② Disconnect from the mains outlet to avoid the dragging the power cord.
6) Environment requirements
① Do not use in or near water, the unit is designed only to capture water droplets. Excess
water ingress will cause damage.
② The system should be free from possible hazards caused by pressure, temperature,
humidity, ventilation, sunlight, dust, salt, sulphur-containing air, etc.
③ Avoid tilting, or the bumping of the system when moving.
④ Never expose the system to chemicals or place the it near a chemical storage area.
⑤ Clean and disinfect the system after every dental procedure, the suction mouthpiece hood
is autoclavable.
7) Should a problem occur, please contact a BA INTERNATIONAL authorized dealer or
technical support team. Do not disassemble or attempt to repair.
8）Attempts at modifications are strictly forbidden.
9) In case of following situations, turn off the equipment and disengage the power cord
from the wall mains outlet.
① Before each filter replacement, equipment cleaning, maintaining, or repairing.
② Should any irregularities arise, such as heat and/or noise.
③ When the system is not in use for two days.
3