ESYLUX PD-C360i/24 DUODIMplus-FM Manual Del Usuario página 18

Afterglow feature
After movement is no longer detected and the preset time setting has
expired, the orientation light switches on for an adjustable period of
time.
GB
Nightlight feature
After the light value falls below the preset light value, the orientation
light switches on. It remains on until a movement is detected or until the
light value is exceeded.
8 • SETTINGS AND FUNCTIONS VIA MOBIL-PDi/plus REMOTE CONTROL
(FIG. 6)
NOTE: For optimum reception, when programming the settings, point the
remote control at the detector. Note that if the sun shines directly on the
sensor, the standard detection range of approx. 8 m may be dramatically
reduced owing to the sun's infrared rays.
Temporary functions
After the button is pressed, the functions are carried out immediately,
but they are not permanent.
Button Customised setting
Manual ON/OFF
See section Buttons S1 – S3/
Remote control C1 – C3 + light ON/OFF
Change DIM value
See section Buttons S1 – S3/
Remote control C1 – C3 + light ON/OFF
18
Change OK function for DIM value
See section Buttons S1 – S3/
Remote control C1 – C3 + light ON/OFF
Channel selection
See section Buttons S1 – S3/
Remote control C1 – C3 + light ON/OFF
End the "test" function
Manual light ON/OFF and time setting
Return to preset mode
During test mode, channels 1 to 3
are permanently switched on
When each movement is detected, regardless of the
ambient lighting level, the blue mode LED flashes twice.
To exit, press the "Reset" button.
Programming
Programming with the following functions is only possible in
programming mode. All data is immediately and permanently
saved. After exiting programming mode, the functions are
performed.
Button Customised setting
Enter programming mode
Blue LED lights up and indicates programming mode.
Light channels C1 + C2 are switched on with 100 %
luminous efficiency. Whilst in programming mode,
the detector's movement sensor is disabled.