Problems And Solutions - Fisher-Price POWER WHEELS Ford F-150 Manual Del Usuario

e IMPORTANT! If you experience a problem with your vehicle, fi rst check the Problems and Solutions Guide below. If you still experience a problem,
please contact Consumer Relations.
PROBLEM
Vehicle does not run
e PROBLEMS AND SOLUTIONS
POSSIBLE CAUSE
Undercharged battery
Charger is not working
Tripped thermal fuse
Loose wire or loose connectors
Dead battery
Electrical switch damage
Motor damage
Charge the battery. A new battery should have been charged for at least
18 hours before using the vehicle for the first time. After first-time use,
recharge the battery for at least 14 hours after each use. Never charge
the battery longer than 30 hours.
Check all connectors. Make sure the charger connector is plugged into
the battery, and that the charger is plugged into the wall.
Make sure power flow to the wall outlet is "ON".
There is no sure way to tell if your charger is working unless you have
a volt meter. If you suspect there is a problem with your charger,
contact our Consumer Advisory Service.
The built-in thermal fuse may "trip" and shut down operation of the vehicle
if the vehicle is overloaded or the driving conditions too severe. Once a fuse
has "tripped", remove your foot from the pedal and wait approximately 25
seconds before operating the vehicle again. To avoid repeated automatic
shutdowns, do not overload the vehicle by exceeding the 59 kg (130 lbs)
maximum weight capacity or by towing anything behind the vehicle. Do not
drive up hills or run into fi xed objects, which can cause the wheels to stop
spinning while power is still being supplied to the motors. If a thermal fuse
continually trips, contact Consumer Relations.
Check all wires and connectors. Make sure the motor harness connector
is plugged into the battery, and that there are no loose wires around
the motors.
If your battery is old or if you have not followed Battery Care instructions,
your battery may be dead. If you are unsure whether or not the battery is
dead, contact Consumer Relations.
The electrical switches can become corroded due to exposure to water
or moisture, or can jam due to loose dirt, sand or gravel. Contact
Consumer Relations.
Contact Consumer Relations.
28
SOLUTION
K9829pr-0720