Quick Installation - Tripp-Lite OmniSmart 300 Manual Del Propietário

Quick Installation

Plug your UPS into an
1
electrical outlet.
Plug your computer,
2
monitor and external
modem into battery-
supported outlets.
Plug other equipment
into surge-only outlets.*
Optional (Select models)**
Using Tripp Lite cable (if supplied),
connect the DB9 port of your
computer to the DB9 port of your UPS.
Load software (if supplied) and run
installation program appropriate for
your operating system.
Using telephone cords, connect your
wall jack to the UPS jack marked "LINE"
(or "IN"). Connect your equipment
to the UPS jack marked "EQUIP"
(or "OUT").
Turn your UPS's power
3
switch ON.
*Separate battery-supported/surge and surge-only outlets are available only on select models (identified on the back of
your UPS). Your UPS is designed to support only computer equipment. You will overload your UPS if you connect
household appliances, laser printers or surge suppressors to the battery-supported outlets. **Phone line and DB9 port
connections are optional. Your UPS will function properly without these connections. Make sure the equipment you
connect to the UPS's telephone jacks is also protected against damaging surges on the AC line.
3