Resetting To Factory Settings - Beem Classico Manual De Instrucciones

31
Setting the Quantity of Milk Froth
On the milk tank cover (6) there is a dial (5) which can be used to set whether more milk froth or
more hot milk should be added to the speciality coffee.
For more milk froth: Turn the dial to the top right.
For more hot milk: Turn the dial to the bottom left.

Resetting to Factory Settings

If the quantities of espresso and milk are to be reset to the quantities which are preset at the
factory, proceed as follows:
1. Switch off the device using the
2. Press the buttons
3. Switch the device back on using the
fi ve beeps will be heard.
4. Let go of the
Preparation
NOTICES
• Do not operate the device without water. If this does happen, the device issues an error
message (several beeps in succession) (see the "Troubleshooting" chapter).
• Never use the device without a suitable container below the coffee outlet and the
milk nozzle.
The device remains switched on and the control panel is lit up for up to 30 minutes after
the last action. During this time, the water in the water tank (2) and the cup warmer (15)
are heated. Once the 30 minutes have elapsed, the device switches to stand-by mode and
may need to be switched on again using the
If the brewing process is to be aborted prematurely, press the chosen button again. You will
hear a beep, and the control panel is fully lit up again. The device switches to stand-by mode.
Espresso / Double Espresso
The perfect amount of espresso to suit your own taste can be programmed in the device
(see the "Handling and Operation" chapter | "Programming Quantities")
1. Fill the water tank (1) with water (see the "Handling and Operation" chapter | "Filling the
Water Tank").
2. Place the fi lter you want into the portafi lter (12) (see the "Handling and Operation" chapter |
"Inserting / Removing the Filter in the Portafi lter").
3. Fill the fi lter with coffee powder (see the "Handling and Operation" chapter | "Filling the Filter
With Coffee Powder").
03428_DE-EN-FR-ES-IT_A5_V4.indb 31 03428_DE-EN-FR-ES-IT_A5_V4.indb 31
button (16).
(24) and (17) simultaneously and keep them pressed.
button. The control panel (3) will fl ash fi ve times and
and buttons. The quantities are now reset to the factory settings.
button (16).
EN
22.07.2019 10:13:23 22.07.2019 10:13:23