Descargar Imprimir esta página

Trix BR 103 Serie Manual De Instrucciones página 18

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
Operating Information
• The headlights go off in a signal block.
Notes on operation with direct current
• A filtered direct voltage is required for operation.Ope-
rating systems with pulse duration control are therefore
unsuitable.
• Minimum voltage: 7 – 8 Volt =.
Notes on the DCC multi-train system
• Set address ex works: 03.
• Speed levels: 14 speed levels preset in DCC operation;
28 or 128 speed levels are detected and set automati-
cally.
• Controllable Functions:
- f0: Direction-dependent Headlights
- f1: Pantograph above driver's cab 1 (front).
- f2: Pantograph above driver's cab 2 (rear).
- f4: Low Speed Switching Range
• Changes in the registers are only effective for the most
part in DCC operation. For that reason you should
leave the factory settings in conventional DC operati-
on. Malfunctions resulting from changes to the factory
settings of the locomotive electronics are caused by the
operator and do not give grounds for complaint under
our guarantee or warranty obligations.
• The installed locomotive electronics offer a wide range
of adjustment options according to the NMRA/DCC
18
standard. A series of parameters are stored to this end
in what are known as CVs (abbreviation for Configura-
tion Variable). Please refer to the operating instructions
for your system for the procedure for changing these
setting values. This operating system must comply
with NMRA/ DCC standards if a perfect programming
function is to be guaranteed. The use of an unsuitable
operating system does not give grounds for complaint
under our guarantee or warranty obligations.
• We recommend that you always change just one setting
value and see what effect this has.
• CV 8 is an important CV. Writing the value „8" will result
in the complete component being reset to the factory
settings that applied at the time of delivery!

Publicidad

loading

Este manual también es adecuado para:

E 03 serie