Attaching The Viewfinder To A Camera; Detaching The Viewfinder; Adjusting The Position - Sony HDVF-L10 Manual De Instrucciones

Attaching the Viewfinder
to a Camera
CAUTION
When the viewfinder is attached, do not leave the
viewfinder lens facing toward the sun. Direct sunlight
can enter through the lens, be focused in the viewfinder
and cause fire.
Notes
When attaching the viewfinder, make notes of the
following points.
• Be sure to power off the camera before coupling the
viewfinder connector to the camera's VF connector.
If you make this connection when the camera power is
on, the viewfinder may not function properly.
• Couple the viewfinder connector firmly to the
camera's VF connector. If the coupling is loose, noise
may appear on the video or the tally indicator may not
operate properly.
1
1 Loosen the viewfinder left-to-right
positioning ring on the camera, 2
attach the viewfinder to the viewfinder
fitting shoe on the camera, and 3
tighten the viewfinder left-to-right
positioning ring.
Stopper
2
Couple the viewfinder connector to the
VF connector on the camera.
VF connector

Detaching the viewfinder

You can detach the viewfinder by following the
attaching procedure in reverse order, but there is
an additional action to take: when detaching the
viewfinder from the fitting shoe, pull up the
stopper. (See the illustration in step 1.)

Adjusting the Position

To adjust the viewfinder left-to-right position,
loosen the left-to-right positioning ring on the
camera, and to adjust the front-to-back position,
loosen the front-to-back positioning knob on the
camera.
Viewfinder left-to-right positioning ring
Viewfinder front-to-back positioning knob

Attaching the Viewfinder to a Camera

23