HP Smart Tank 7000 Serie Guía De Referencia página 3

Printer hardware setup information
Follow instructions in the HP Smart software for easy setup. Visit 123.hp.com
to install software.
Open ink bottles
The ink bottles included with the printer or sold by retailers could have a screw-cap or a flip-cap.
Follow the instructions to open your ink bottles.
For ink bottles with screw-cap:
Twist open the cap.
For ink bottles with flip-cap:
Twist open the cap and remove the seal.
Replace the cap. Flip open the top of the cap.
Fill the ink tanks
Refill the ink tanks when the printer is low
on ink or out of ink.
1. Open the ink access door and tank covers.
2. Open the cap of the ink tank to be filled.
3. Place the opened bottle upside down on the
tank so it clicks into place. Let the ink drain
into the tank.
4. Close the bottle cap, tank cap, and tank
covers. Repeat the above steps as needed
to fill other tanks.
5. When tanks are filled, close the ink access
door securely and wait for 10 seconds.
Make sure to close the ink access door
so the printer can detect ink, before
you install printheads.
Note: If there is leftover ink, keep the bottle
upright in a cool and dry place.
28B54-90008_MNL_RG_ ST7000-7300_AMS_4L.indb 3
1
3
5
2
4
4/23/2021 1:57:41 PM