Safety Warnings - Uline H-3069 Manual Del Usuario

2. Place the item to be stapled (D) below the stapler
head (E). (See Figure 4) Pull the trigger (F).
F
E
D
NOTE: Read the following warnings to prevent
injuries to yourself and those around you.
• Never use oxygen, combustible gases, CO2, steam
or high pressure gas tanks as power sources. The
stapler may explode and cause serious injury.
• Use only dry, clean, pressure-regulated compressed
air to drive the stapler.
• Eye protection must always be worn by the operator
and others in the work area.
• Always use personal protection equipment as
required, such as ear protection, hard hats, etc.
• Never use a defective stapler. Ensure the trigger
operates properly and all screws and nuts are
securely tightened at all times.
• Do not modify the stapler.
• Always disconnect the stapler from the air supply
and empty the magazine when the stapler is not in
use or when servicing.
• Never leave a loaded stapler unattended.
• Always assume that the stapler is loaded.
• No horseplay. Respect the stapler as a working
implement.
PAGE 2 OF 9
OPERATION CONTINUED
REMOVING STUCK STAPLES
Figure 4
1.
2. Remove any staple remnants inside the tool nozzle

SAFETY WARNINGS

• Never point the stapler at yourself or anyone else,
• Connect the stapler to the compressed air line
• Ensure that the air hose has the right dimension
• The stapler and the hose must have a coupling
• Avoid personal injury. Never hold your hand in the
• Do not load the stapler with the trigger depressed.
• Use only Josef Kihlberg staples, type 777.
• Always place yourself in a firmly balanced position
WARNING! Always disconnect the tool from the
air supply, empty the magazine, and read the
safety warnings before troubleshooting.
Pry the door open from the lefthand side with a
screwdriver.
and close the door again until it clicks shut.
whether it contains staples or not. Always remove
finger from trigger when not driving staples.
before loading staples. Maximum air pressure is 7
bar.
to avoid pressure drops which might cause
malfunctioning. Minimum: 1/4".
which automatically bleeds all air pressure from the
stapler when it is disconnected.
jaws of the stapler.
when using or handling the stapler.
0421 IH-3069