PLASMACLUSTER OPERATION
The Plasmacluster Ion generator inside the air
conditioner will release positive and negative
plasmacluster ions into the room.
Approximately the same numbers of positive and
negative ions released into the air will reduce
some airborne mold.
1
During operation, press the
PLASMACLUSTER button.
• The remote control will display "
• The blue PLASMACLUSTER lamp on the
unit will light up.
DISPLAY
MODE
1h
CLEAN
FAN
TO CANCEL
Press the PLASMACLUSTER button again.
• The PLASMACLUSTER lamp on the unit will turn
off.
NOTE:
• Use of the PLASMACLUSTER operation will be
memorized, and it will be activated the next time
you turn on the air conditioner.
• To turn off the PLASMACLUSTER lamp, press the
DISPLAY button.
• To perform the PLASMACLUSTER operation
without accompanying heat, cool or dry mode,
press the PLASMACLUSTER button while the unit
is not operating. The mode symbol of the remote
control will go off and the fan speed can not be set
AUTO.
".
1
SET/C
SELF CLEAN OPERATION
SELF CLEAN operation will provide effect to
reduce the growth mold fungus, and to dry inside
of the air conditioner unit with Plasmacluster ions.
This operation is accompanied by FAN or HEAT
mode. Utilize the operation at seasonal change
over terms.
Mold fungus already grown can not be eliminated
by this operation.
1
Press the SELF CLEAN button when the
unit is not operating.
• The remote control displays "
• The red OPERATION lamp (
green SELF CLEAN lamp (
PLASMACLUSTER lamp on the unit will light up.
• The unit will stop operation after forty minutes.
DISPLAY
MODE
FAN
TO CANCEL
Press the SELF CLEAN button.
Alternatively, turn the unit off by pressing the ON/
OFF button.
• The red OPERATION lamp (
CLEAN lamp (
lamp on the unit will turn off.
NOTE:
• You cannot set the temperature, fan speed, air fl ow
direction or timer setting during the SELF CLEAN
operation.
E-9
".
), the
) and the blue
1h
1
CLEAN
SET/C
), the green SELF
) and the blue PLASMACLUSTER