Configuring An Id; Validating The Servo Id - XYZ Robot A1-16 Manual Del Usuario

Registering an ID

Configuring an ID

1. Enter the correct servo ID in the ID field.
2. Click Set under Parameter description.
The LEDs will blink to indicate a new ID is being configured for the connected servo.
Click OK to confirm.

Validating the Servo ID

Finally, assembly the new smart servo to the correct position. Please refer to the Assembly Manual to
identify the servo position.
After assembly, use XYZrobot Editor to validate the servo ID. In the XYZrobot Editor Pose Editor, move
the new servo's slide bar. If the slide bar works, the servo ID is defined.
03