Whirlpool Acros AF30212 Instructivo De Instalación, Uso Y Manejo página 6

OVEN WITH THERMOCONTROL
• How to light the oven burner with thermocontrol, manually:
1.- Open the oven door, light a match and place
the flame at the igniter hole in the front of the
oven tray while you push in and turn the oven
knob 1/4 of the way, the burner will light
immediately.
2.- Verify that the oven burner has been ignited.
• How to light the oven burner with 4 steps thermocontrol,
manually:
1.- Open the oven door, light a match and place
the flame at the igniter hole in the front of the
oven tray while you push in and turn the oven
knob 1/4 of the way, the burner will light
immediately.
2.- Verify that the oven burner has been ignited.
• The models with thermostat have a pilot in the oven burner,
to adjust it:
1.- Without the manifold panel, locate the adjustment screw on
the thermostat, see the illustration on the right side.
2.- Remove the oven tray (see page 11) and turn the knob
approximately 30° until you feel a small stop,
turn the oven pilot on with a match or a lighter.
Pilot Position.
3.- With a flat and thin screwdriver turn the adjustment screw
until you get a flame approximately 3/8" tall.
4.- Replace the manifold panel, screws and knobs.
• How to adjust the oven burner air shutter:
1
Remove the
oven rack.
(See page 9).
6
2
Remove the oven
tray. (See page 11).
OFF
MAXIMUM
FLAME
OFF
MAXIMUM
FLAME
STM00396 R.0
ADJUSTABLE FLAT SCREW
FOR THE OVEN PILOT
3
A - Locate the screw on
the air shutter and
loosen it.
B - Turn around the air
shutter.
C - Turn on the oven.
D - Verify that the flames
are blue.
E - If the flames are not
blue, repeat since
step B, when the
flames are adjusted,
tighten the screw
again.
F - Replace the oven tray
and the oven rack.
MINIMUM
FLAME
MINIMUM
FLAME